In the tab labeled "Slice Control", click on View Controls. This means that increasing the total size of your dinosaur wil increase its resolution, making it appear much better defined.Īt the moment, the slices are all oriented so that there are many small slices rather than few big slices. The thickness of the slices, however, will remain the same. If you change one dimension, all of the other will scale accordingly. In the tab labeled "Set Physical Object Size", enter the desired dimensions of your dinosaur. In the tab labeled "Cut Sheet Layout", set the print size to match the dimensions of whatever piece of cardboard you're using, as well as the appropriate thickness. Notice that a new tab has appeared on the right, displaying all of the finished pieces. We're about to change all the slices around a bit, so don't worry about those just now. The blue slices indicate areas that would be structurally flimsy or poorly connected to the rest of the model. The dinosaur should now appear as a rather low-resolution stack of thick slices. Your options are Interlocking Slices or Stacked Slices. If all has gone well, you should now see a dinosaur doing an impressive tail-stand in the D window. If you've got something other than a T-Rex that you'd prefer to make, then go ahead and do that. 123D Design Tutorial - Construct: Extrude, Sweep, Revolve, Loft This is where you choose the object that you'd like to slice. In the top left, you'll see a tab labeled "Start shape". You should be presented with a clean, almost empty interface. You can now buy a pre-cut version of this kit at the Instructables Store! First things first: open up D Make. There are also plans in the works to release an online version of the software which will run on PCs as well as Macs, hopefully within the next few months. You will, however, require either a laser cutter or a heck of a lot of patience for cutting cardboard. It's extremely simple to do, even if you have no prior experience of using 3D software. In this tutorial, I'm going to guide you gently through the process of using Autodesk D Make to turn a 3D model of a dinosaur into a cardboard model kit.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |